Categories

Duckbills

Standard would be 10x32 at .75 inch spacing between the two holes. Most modern bottomline asas and drops use this spacing. This frame became the standard I would guess after WGP's Sniper two and then Autocockers. AGD (made by WGP) also used these same frames (although slight milled out for the sear on Automags. Non standard would be 10x32 at 1.25 inch spacing and would apply to older pumps specifically grey ghosts and other lapco guns. Carters also use this spacing. The other type of spacing would be spyder spacing which is the two diagonal holes which are a smaller outer diameter than 10x32 screws.
Filter
Set Descending Direction

60 items

Page
per page
View as Grid List
Filter
Set Descending Direction

60 items

Page
per page
View as Grid List